How to properly install the engine belt and pulley
Oct 05, 2019
Some engines use a flat fan belt that should be checked for fit to the pulley when mounted on a pulley. The flat belt should be well matched with the pulley, otherwise the life of the belt will not last long. The V-belt is used on some models, and should be corrected in time when an error occurs. Phenomenon: When the engine is running, there are abnormal noises such as rustling, squeaking, squeaking, etc. When the engine is stopped, you can use your hand to move the belt wheel to check if there is any amount of sputum. If the crevice is large, the belt should be replaced. Medium wheel.
When the vehicle is not replaced in time, sometimes the amount of the medium wheel swings causes the belt to accelerate and wear. Sometimes the belt wheel is stuck and the belt is polished, sometimes the pulley itself falls off, the belt is undocked, the engine generator and the water pump, and the steering Power-assisted pumps, air-conditioning pumps, and other components that require engine power lose power sources and cause the vehicle to break down and fail to drive normally.
In the case of a car engine running between 60,000 and 90,000 km, we should check the wear of the belt, and also pay attention to check the working condition of the engine belt wheel. If there is an abnormality, it should be replaced, even if the belt is not worn seriously, replace the engine belt wheel. Belt daily inspection method
The inspection of the belt mainly includes two aspects: belt tension and belt wear.
First check the tension of the belt. At this time, use the thumb to strongly press the belt between the two pulleys. The pressing force is about 10 kg, and if the belt pressing amount is about 10 mm, the belt tension is considered to be suitable. If the amount of reduction is too large, the tension of the belt is considered to be insufficient. If the belt has almost no reduction, the tension of the belt is considered to be too large. When the tension is insufficient, the belt is prone to slip. When the tension is too large, it is easy to damage the bearings of various auxiliary machines. To this end, the relevant adjustment nut or bolt should be loosened to adjust the tension of the belt to the optimum state.
In addition to this, you must also pay attention to the wear of the belt. The old belt is heavily worn, causing a sharp drop in the contact area between the belt and the pulley. At this time, as soon as the belt is pressed hard, the belt sinks deeply into the groove of the pulley. The rubber of the belt also has an aging problem. If the belt rubber is seriously deteriorated, the new belt must be replaced in time.
There are several belts at the front end of the engine, and each belt plays an important role. On the engine, various auxiliary machines are driven by a belt drive, such as an air conditioner compressor, a power steering oil pump, an alternator, and the like. If the belt breaks or slips, it will cause the associated auxiliary machine to lose its function or degrade its performance, thus affecting the normal use of the car. Therefore, daily inspection of the belt is very important.






